Cracked, sunken, stuck or sheared sprinkler heads replaced with matching parts and adjusted so spray reaches the right place again.
The most common irrigation repair is also the one that wastes the most water. A mower clips a head, a car rolls over one or the plastic simply gets old and cracks, and suddenly a geyser shoots into the air or a head sits tilted and sprays the street. Water pours out of the break and the lawn around it floods, while the area the head used to cover goes dry.
We replace broken heads with the same type, brand where possible and nozzle size so output matches the heads around it. Mixing different nozzles on one zone gives uneven watering, so matching matters. We adjust arc and radius, set height so mowers pass over, and check the riser and fittings below for damage. If many heads are cracked or the plastic has faded and gone brittle, we tell you honestly whether replacing all of them is the smarter fix.
Same type and nozzle output keeps the zone balanced, instead of creating new wet and dry areas.
Arc, radius and height are set for coverage and so mowers pass over without clipping.
Risers and fittings are inspected, because damage often hides under the broken head.
If the whole set is aging, we say so and explain when replacing all heads makes sense.
Drag the handle to compare.
BeforeAfterEven output.
No hidden damage.
Set correctly.
Mower friendly.
Coverage confirmed.
Replace one or all.
Every topic has its own page with what to expect and how we approach it.
Home situationOlder Homes and Existing LawnsMature lawns, old systems and tree roots call for careful work. Here is how to add or renew…Learn more 
Home situationTownhomes and Small YardsSmall yards need precise watering. Here is how to keep water on the lawn and off the walls…Learn more 
Equipment guideRotor SprinklersRotors throw water a long way in slowly turning streams. Here is where they shine, where they do…Learn more Check the signs you see in your yard and get a likely cause with the next step.
You tell us about your yard and what you want, a new system, a repair or a tune-up, and we set a visit that fits your day.
We walk the property, find the water source and valves, test pressure and flow, look at every head and zone and take photos of anything of note.
We explain your options for zones, heads, drip, controllers and savings, sketch the layout and give you a written scope with clear timing and pricing.
We arrange for underground utilities to be located, protect the lawn, driveways and beds and mark every head, valve and pipe run before we dig.
We install or repair pipe, valves, heads and wiring with the right parts for each zone, flush the lines and keep the site tidy as we work.
We program the controller, test every zone with you, walk through watering and winterizing in plain steps and set a reminder for your next check.
A head has probably been cracked or sheared. Turn off the zone or system and call us to replace it.
Often, but matching the type and nozzle and avoiding damage to the riser takes some care. We can do it quickly.
Mowers, vehicles and age are the usual causes. Setting height correctly and using more durable heads helps.
If most are old, brittle or mismatched, replacing them together saves repeat calls and improves coverage.
They can, if the nozzle differs. We match the output so the zone stays balanced.
Head AdjustmentTilted, misaimed and mis-set sprinkler heads adjusted for arc, radius and height so water lands on the lawn…Explore 
Nozzle and Filter CleaningClogged nozzles, screens and filters cleaned or replaced so spray patterns return to normal and coverage is even…Explore 
Sprinkler RepairFast, careful sprinkler repair that finds the real cause, fixes it properly and leaves your system running evenly…Explore 
Nozzle UpgradesRotary and matched-precipitation nozzles installed to apply water more slowly and evenly, cutting runoff and waste without replacing…Explore Tell us about the project and we will call you back to talk it through.
Or call (615) 357-7797 to talk now.
