Sprinkler lines and heads moved, capped or rerouted when you build a pool, patio, deck, driveway or addition, so the system keeps working.
Construction and sprinklers do not mix well. A pool crew digs through a main line. A new patio buries a head. A driveway widening shears off a valve wire. Often nobody notices until the next time the system runs, and then a zone is dead, a geyser appears or a section of lawn goes dry. Planning for irrigation before and after construction avoids expensive surprises.
We can visit before work begins to mark lines and heads that will be affected, cap and protect pipes that must stay in place and plan the reroute. After construction, we install new lines and heads around the finished structure, reconnect zones and test them. We make sure coverage is restored, spray stays off the new surfaces and the controller is reprogrammed for any new layout. If you need new zones for the new landscaping, we can add them at the same time.
We mark lines and heads before the dig, so crews know what to avoid and what to protect.
Lines that must be cut are capped properly to prevent leaks and to keep the rest of the system running.
New lines and heads restore coverage around the new structure and keep every zone working.
Heads are set to keep water off new patios, decks, pool surrounds and finishes.
Drag the handle to compare.
BeforeAfterSystems kept working.
Lines rerouted.
Know what is at risk.
No hidden leaks.
Every zone tested.
Reprogrammed.
Every topic has its own page with what to expect and how we approach it.
Home situationPool and Patio LandscapesPools, patios and outdoor kitchens need irrigation that keeps beds green and spray off surfaces. Here is how…Learn more 
Home situationOlder Homes and Existing LawnsMature lawns, old systems and tree roots call for careful work. Here is how to add or renew…Learn more 
Home situationSelling Your HomeA green lawn and a working system help a house sell. Here is what to check and fix…Learn more Enter your lawn and bed areas, head type and water flow to see how many heads and zones a sprinkler system may need.
You tell us about your yard and what you want, a new system, a repair or a tune-up, and we set a visit that fits your day.
We walk the property, find the water source and valves, test pressure and flow, look at every head and zone and take photos of anything of note.
We explain your options for zones, heads, drip, controllers and savings, sketch the layout and give you a written scope with clear timing and pricing.
We arrange for underground utilities to be located, protect the lawn, driveways and beds and mark every head, valve and pipe run before we dig.
We install or repair pipe, valves, heads and wiring with the right parts for each zone, flush the lines and keep the site tidy as we work.
We program the controller, test every zone with you, walk through watering and winterizing in plain steps and set a reminder for your next check.
Usually yes, with planning. We mark lines before the dig and reroute and reconnect afterward.
Tell us and your contractor early. Marking lines and heads in advance prevents most damage.
Turn off the system and call us. We cap, repair and reroute as needed.
Yes. We often add zones for new beds and lawn areas at the same visit.
Not after we adjust it. Heads and arcs are set to keep water off new surfaces.
Zone AdditionsNew zones added to your existing system for a new bed, a new lawn area, an addition or…Explore 
Leak Detection and RepairHidden leaks found with careful testing and repaired with minimal digging, so you stop wasting water and stop…Explore 
Line Break RepairCracked and cut sprinkler pipe repaired with proper fittings, tested under pressure and buried with the lawn put…Explore 
Free EstimatesA free on-site visit with measurements, honest options and a written scope for installation, repair or upgrades, with…Explore Tell us about the project and we will call you back to talk it through.
Or call (615) 357-7797 to talk now.
